Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateGenie Torsion Spring Replacement: The Boulder City Owner’s Guide
We replace failed Genie torsion springs with model-matched parts, and the installed price in Boulder City runs $180 – $340 for most residential doors. We can often get to a broken spring the same day you call. Every job is priced upfront before we touch a tool, and it’s backed in writing by our 90-Day Done Right Promise.
Owners usually find this out the hard way. You hit the button, the opener hums for a second, and nothing moves. Or the door lifts six inches and stops dead. Sometimes there’s a bang from the garage that sounds like a gunshot and the door never opens again. That bang is a torsion spring letting go. Genie is one of the most common opener brands on Clark County doors, and the spring system over the door is what actually carries the weight. The opener just tells it when to move. When that spring snaps, the whole thing stops working all at once. Call us at (833) 605-8582 and a live person answers, day or night.
Which Genie Models This Applies To
Genie builds openers, not springs. The torsion spring over your door is sized to the door, not to the Genie head unit on the ceiling. So “Genie torsion spring replacement” really means matching a new spring to your door and confirming it works with the Genie operator you have. That covers the whole Genie line, from the older ChainMax and Excelerator units to the current SilentMax and StealthDrive models. The spring doesn’t care which one is bolted to the ceiling.
What does matter is the door. Spring size comes down to two numbers: the wire gauge and the inside diameter, matched to the weight of your door and the height of the track. A two-car steel door in Boulder City may carry one spring or two, depending on whether it was built as a single-span or a double-spring setup. We measure the door, check the drum and cable configuration, and match the spring to what’s actually there.
On the OEM-versus-aftermarket question, we’re plain about it: for Genie openers we use factory-familiar parts, and for springs we use quality replacement springs sized to your door. Genie-branded springs aren’t a thing the way Genie-branded remotes are. What you want is a spring wound to the right spec, not a label. We’re an independent service provider and not affiliated with Genie, and we service LiftMaster and Chamberlain doors on the same street. A brand on the box doesn’t change how the door hangs.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Signs Your Genie Torsion Spring Replacement Is Failing
Most spring failures in Boulder City announce themselves before they snap. Here’s what to watch for:
- The door feels heavy when you lift it by hand. A working spring makes a balanced door feel light, almost like it’s helping you. When the spring is losing tension, you’re fighting the full weight of the door. If you can barely lift it, that’s your sign.
- A visible gap in the coil. Look at the spring above the door, not the one beside the track. A clean break shows as a two-inch gap in the winding. That’s a snapped spring, and the door won’t open safely until it’s replaced.
- The opener strains or quits partway up. Your Genie unit is designed to lift a balanced door. When the spring weakens, the opener works harder, and newer Genie models with safety sensors will reverse or stop rather than force it. The opener isn’t the problem; it’s doing its job.
- The door slams down instead of lowering smoothly. A tired spring can’t hold back the door’s weight on the way down. That hard landing is rough on the door, the tracks and anything under it, including a person.
- Loud creaking or popping from the torsion bar. Dry or worn springs and their bearings groan under load. Sometimes it’s just lubrication, but on an older door it’s often the spring telling you it’s near the end.
One detail worth knowing: Nevada’s dry air and big temperature swings between summer afternoons and winter nights work springs harder than a milder climate would. A spring that would last fifteen years in a damp coastal town can give out sooner here. We see a lot of spring failures in Boulder City on doors that are ten to twelve years old, especially on south-facing garages that bake in the afternoon sun. If your door is in that range and starting to feel heavy, it’s worth a look before it snaps.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Spring repair in Boulder City runs $180 – $340 installed. That’s the spring, the labor to wind it safely, and a full balance check on the door before we leave. The price you’re quoted is the price on the bill. We state it upfront, before any work begins, so there are no surprises when we hand you the invoice.
What moves you within that range:
- One spring or two. A single-spring door sits near the low end; a double-spring setup or a heavy wood door runs higher.
- Spring size and gauge. Larger, heavier doors need heavier springs.
- Condition of the cables and drums. If the spring took a cable with it, that’s added cost. Cable repair runs $130 – $250.
- Access and door height. An eight-foot door takes more spring than a seven-foot door.
Most Genie spring jobs are finished in a single visit because we arrive with the parts already matched to your door. If it’s not right, we come back. That’s the 90-Day Done Right Promise, in writing on every job, no arguing. Seniors and veterans get a permanent 5% discount, and we take $50 off any repair over $250.
DIY or Call Us?
We’ll be straight with you about the safety side, because it matters. A torsion spring is under hundreds of pounds of tension even when the door is closed. Winding or unwinding one with the wrong bars, or with the right bars and a moment’s slip, can break an arm or worse. This is not a part to swap yourself, and no honest tradesperson will tell you otherwise. The springs and cables that carry a door’s entire weight are the one part of a garage door we ask homeowners never to touch.
What you can safely check: whether the door feels heavy when you lift it by hand, whether there’s a visible gap in the spring coil, and whether the opener stops or reverses. Those checks tell you the spring is the problem. They don’t require you to touch it.
If it’s the spring, call us at (833) 605-8582. A live person answers, and we’ll tell you what it’ll cost before we come out.
FAQs
How long do Genie garage door torsion springs last in Boulder City? Most last ten to fifteen years, and in Boulder City’s dry heat many fail closer to the ten-year mark. Springs on south- or west-facing garages wear faster because the afternoon sun works the metal. A door that’s ten years old and starting to feel heavy is worth checking before it snaps. Call (833) 605-8582 for a free estimate.
Can a broken Genie torsion spring be repaired instead of replaced? No. Once a spring has snapped, it can’t be repaired or re-wound; it has to be replaced. A spring that’s merely weak can sometimes be re-tensioned, but springs are cheap enough that replacement is usually the square deal. We’ll tell you which you need after we look. Call (833) 605-8582.
How long does a Genie torsion spring replacement take? Most take one to two hours, and many are finished in a single visit. The door is balanced and tested before we leave. If you call early in the day, there’s a good chance it’s done the same day. Call (833) 605-8582 to check availability.
How do you source the right spring for my Genie door? We measure the door’s weight, height, wire gauge and inside diameter, then match a replacement spring to those specs. Genie builds openers, not springs, so the match is to the door, not the brand on the motor. We use quality replacement springs sized to your door. Call (833) 605-8582 for a free estimate.
Whether it’s a snapped spring or you’re not sure what’s wrong, call Mainspring Garage Door Co. Boulder City at (833) 605-8582 for a free estimate. A live person answers around the clock, the price is stated upfront, and the work is backed in writing for 90 days. We stand behind it.
Written by the team at Mainspring Garage Door Co. Boulder City, serving Boulder City and nearby areas.